IP Failover

You can set IP failover along with NVR/VMS failover settings.

When IP failover is enabled, the main NVR/VMS and failover NVR/VMS use a specific virtual IP, and CMS or NDS act as the specified virtual IP, allowing for use without special manipulation in the event of a failure.

Normally, the main NVR/VMS is set to virtual IP, but in the event of a failure, the failover NVR/VMS is converted to virtual IP.

IP failover settings

Set both the main NVR/VMS and the failover NVR/VMS.

In the connected network interface, check IP failover and click the Settings button.

Enter the virtual IP address to use in the same network environment. The main NVR/VMS and failover NVR/VMS must have the same virtual ID.

Check with the master for the main NVR/VMS and not the failover NVR/VMS with the master.

Register as a failover IP on CMS

You can use CMS server management by registering hosts with addresses set to failover IP.